iPhone 7 Plus Stuck at Recovery Mode and Error 9 when Restore

iPhone 7 Plus Stuck at Recovery Mode and Error 9 when Restore

Malfunction Phenomenon

The iPhone 7 stuck at recovery mode, and it reported error code 9 when restoring with iTunes. 

iPhone 7 Plus Stuck at Recovery Mode iPhone 7 Plus Stuck at Recovery Mode and Error 9 when Restore

Trouble Shooting

According to repair experience, error code 9 usually caused by the malfunction of NAND flash U1701 or EEPROM U2301.

We checked the NAND by measuring the voltage on C1721, C1702, and C1730, the value was 3.0V, 0.9V, and 1.8V, which were normal.

iphone plus stuck recovery mode error when restore at and g66ld  iphone plus stuck recovery mode error when restore at and  iphone plus stuck recovery mode error when restore at and cel1h

Then continue to check the power for EEPROM by measuring the voltage on C1101.

The value was 1.8V, which was also normal. 

iphone plus stuck recovery mode error when restore at and oo7en

The power for the NAND and EEPROM were both normal, the problem might be from the data line or the chips. We removed the NAND and checked the pads on the PCB, all the diode values are also normal, then use the NAND reader to check the NAND chip, it was also good.

iphone plus stuck recovery mode error when restore at and u80iv

So we can try to replace another EEPROM U2301.

iphone plus stuck recovery mode error when restore at and 76tf4

After replacing another EEPROM, connect with the computer, and tried to restore again, there was no error code anymore and the phone worked normally. 

iphone plus stuck recovery mode error when restore at and

Tips: The Logic EEPROM for iPhone 7/7P can be replaced

iPhone 7 Motherboard Repair Course

Leave a Comment

Your email address will not be published. Required fields are marked *

Scroll to Top