Come riparare il problema di Huawei Mate X2 Charge to Smoke e Cannot Boot

Come riparare il problema di Huawei Mate X2 Charge to Smoke e Cannot Boot

The Huawei Mate X2 is a cutting-edge foldable smartphone with an innovative design that pushes mobile technology to new heights. Due to a charging incident, the phone smoked, leaked current, and had a black screen, rendering it unusable. In this article, you will learn how to fix a damaged motherboard on a HUAWEI Mate X2 due to improper charging. This guide provides valuable insight into the repair process, regardless of whether you are a technician or a DIY enthusiast.

huawei mate x2

Dettagli telefonici:

Modello: HUAWEI Mate X2

Annunciato: 2021, 22 febbraio

Fenomeno dei difetti:

  • The phone emitted smoke during charging and subsequently failed to charge.
  • The screen turned black, and the phone could no longer be powered on.
  • A diagnosis at a repair shop indicated motherboard damage, with a 10mA current leakage on the battery (BATT), preventing the phone from booting.

Risoluzione dei problemi

1: Initial Check:

  • The phone was disassembled, revealing a motherboard that appeared new and had not been previously repaired.
  • Connecting the motherboard to a Alimentazione in c.c. revealed a 10mA current leakage.

2: Boot Attempt:

  • The phone was assembled and an attempt to boot was made.
  • The HUAWEI logo appeared briefly, then the screen went black again.
  • Suspecting a battery detection issue, the battery was activated and tested again, but the phone still couldn’t boot.

2: Thermal Imaging

  • The DC power supply showed current leakage, so a thermal imager was used to identify the overheated component.
  • A small hole was discovered around the display connector under a microscope, indicating potential rail damage beneath the surface.

Even though it’s only a very tiny hole, it’s a serious problem, as the underlying layers with many rails are broken.

Processo di riparazione

1: Damage Assessment:

huawei mate x2 pcb
  • The connector was removed to assess the extent of the damage.
  • The small hole revealed deeper damage than initially expected, with multiple PCB layers likely affected.

2: Repairing Broken Rails

huawei mate x2 scratched pcb
  • The surrounding shielding covers were removed to access the damaged area.
  • The PCB layers were carefully scratched away using a blade knife to expose the broken rails.
  • Around 3-4 layers of rails were found to be broken.

3: Jumping Wires

  • A UV mask was applied to cover the grounding rail layer.
  • Wires were jumped across the broken layers, ensuring each rail was connected to its correct destination without causing shorts or bridges.
  • This delicate process took approximately an hour to complete.

4: Rimontaggio e collaudo

  • The connector and surrounding components, such as small capacitors and resistors, were soldered back onto the board.
  • The phone was reassembled and connected to the DC power supply.
  • The current leakage was no longer present, and the phone successfully booted up.

Consigli per la prevenzione

  • The issue may have been caused by using a poor-quality charger or charging cable.
  • To avoid similar issues, it’s important to use reliable and scientifically tested charging methods to keep your phone safe.

Conclusione:

The Huawei Mate x2 charge to smoke, and it cannot boot or turn on isn’t normal, but it does happen occasionally. REWA Tech wrote this article based on a case study. This tutorial is intended to help repair technicians and DIYers learn something new.

Lascia un commento

Il tuo indirizzo email non sarà pubblicato. I campi obbligatori sono contrassegnati *

Torna in alto